Yes. Although the LA-160W is designed with heating support up to 60°C, you can choose to turn off or bypass the heating and use the machine in cold mode only, especially for heat-sensitive media. However, heating support offers significant advantages when laminating UV or pressure-sensitive films, as it prevents silvering and improves adhesion.

It usually takes about 30 minutes for the machine to reach operating temperature. It is ideal to start heating up before scheduled laminating sessions to reduce waiting time.

The LA-160W has a rated speed of up to 7,500 mm/min (≈ 295 in/min) under optimal conditions. However, in regions with 50 Hz power supply, the machine may be limited to a practical speed of ~6,000 mm/min due to motor or control limitations.

The machine can process a combined thickness (film + substrate) of up to 35 mm (1.38 inches). This range includes standard vinyl, wide format media, sandwich panels or thick substrates with overlays.

The LA-160W uses 3″ (76 mm) cores for both media and film rolls.

• Turn off the power and let the rollers cool down (ideally < 40 °C).
• Clean silicone rollers with a dilute neutral cleaning solution; avoid harsh solvents such as alcohol, thinner or gasoline.
• Lift the top roller after each session to relieve pressure and prevent distortion.
• Clean regularly (daily with light use; more often with heavy use).
• Check rollers regularly for parallel running and proper tension.
• Check and test safety mechanisms (photocell, emergency stop) weekly.

Yes, that is a key design goal. The machine features an intuitive control layout, foot pedal, pressure lever and rewind reel so that one operator can load the roll, laminate and collect the output roll.

Safety features include:

• Photocell sensor: when the optical beam is blocked, the rollers stop automatically
• Emergency stop button: stops operation immediately
• Foot pedal control: the rollers move only when the pedal is depressed
• Control panel lock/locks in certain configurations

• Install on a stable, level floor with minimal vibration
• Keep ambient temperature between 20 and 40 °C and relative humidity between 35 and 65 %.
• Avoid direct air currents, drafts or extreme temperature fluctuations
• Ensure that the power supply matches the rated voltage for your region (e.g. 230 V for EU/Asia).
• Ensure adequate space around the machine for handling rolls and maintenance

Because Mimaki's UV/LED roll printers produce direct dry prints, the LA-160W can accept freshly printed output immediately. The matched speeds, heat support profiles and carefully matched film recommendations ensure seamless transfer. This reduces handling, improves throughput and ensures consistency. For Dimix, this is an attractive value proposition: deliver print + finish as a turnkey solution.